国产肉体XXXX裸体137大胆,国产成人久久精品流白浆,国产乱子伦视频在线观看,无码中文字幕免费一区二区三区 国产成人手机在线-午夜国产精品无套-swag国产精品-国产毛片久久国产

新聞中心

EEPW首頁 > 光電顯示 > 設計應用 > 雙線燈閃光燈電路

雙線燈閃光燈電路

作者: 時間:2010-01-18 來源:網絡 收藏

--Two-wire Lamp Flasher

本文引用地址:http://m.ptau.cn/article/169392.htm

Ideal to operate 3 to 24V DC existing on-circuit lamps

LED operation is also possible


Parts:

R1______________6K8 1/4W Resistor
R2____________270K 1/4W Resistor
R3_____________22K 1/4W Resistor

C1____________220F 25V Electrolytic Capacitor
C2_____________10F 25V Electrolytic Capacitor

D1___________1N4002 100V 1A Diode

Q1____________BC557 45V 100mA PNP Transistor
Q2____________BD139 80V 1.5A NPN Transistor

LP1___________Existing filament Lamp: any type in the range 3-24V 10W max.

SW1___________Existing On-Off switch

B1____________Existing V DC source: any type in the range 3-24V suited to the lamp adopted

Device purpose:

This circuit has been designed to provide that continuous light lamps already wired into a circuit, become flashing. Simply insert the circuit between existing lamp and negative supply.
Especially suited for car or panel pilot lights, this device can drive lamps up to 10W.

Notes:

Break lamp(s) to negative supply connection(s), then insert the circuit between existing lamp(s) connection(s) and negative supply (respecting polarities!).

C1 value can be varied from 100 to 1000F or higher, in order to change flashing frequency.

Although rather oversized, this circuit can also drive any LED, providing a suitable resistor is fitted in series with the light emitting device.

The resistor should be in the range 47R to 2K2, depending on supply voltage.

DIY機械鍵盤相關社區:機械鍵盤DIY




關鍵詞: 電路 閃光燈 雙線

評論


相關推薦

技術專區

關閉