NXPSSL21082,TEA1721和JN5148遙控11WLED驅動參考設計

圖5.JN5148-001基帶處理器框圖

圖6.JN5148-001典型的SPI連接圖
采用SSL21082, TEA1721和JN5148的遙控非隔離11W LED驅動器參考設計
This application note provides basic information on the operation and performance of NXP Semiconductors SSL2108X_DR1166 reference design. It contains complete remote controller 11 W SSL Driver. However, the casing with heat sink, LEDs and 2.4 GHz antenna are not included in the shipment.
The design is based on buck topology which does not provide galvanic isolation. Using the RF remote control, brightness and on/off switch are controlled.

圖7.120 V SSL2108X和DR1166演示板外形圖
11W LED驅動器參考設計包括:
?Large signal board (SSL2108X)
–EMI filter
–Mains rectifier
–Valley fill circuit
–Buck inductor for supply unit
–SSL driver (SSL21082)
?Small signal board (DR1166) buck supply (TEA1721)
–Generates VCC = 2.7 V for JN5148 microcontroller/RF
–Generates VDD = 13.5 V for SSL2108 driver IC
?RF/microcontroller (JN5148)
–Contains microcontroller with flash memory
–Contains 2.4 GHz transceiver
–Contains connector for programming the flash memory

圖8.11W LED驅動器參考設計電路圖(1)

圖9.11W LED驅動器參考設計230V應用電路圖

圖10.帶墻調光器電路的SL2108x電路圖

圖11.DR1166和JN5148 RF/MCU電路圖

圖12.DR1166和TEA1721降壓電源電路
SL2108X 板材料清單:

DR1166 板材料清單:


詳情請見:
http://www.nxp.com/documents/data_sheet/JN-DS-JN5148-1v7.pdf
和
http://www.nxp.com/documents/application_note/AN11126.pdf
評論