国产肉体XXXX裸体137大胆,国产成人久久精品流白浆,国产乱子伦视频在线观看,无码中文字幕免费一区二区三区 国产成人手机在线-午夜国产精品无套-swag国产精品-国产毛片久久国产

新聞中心

EEPW首頁 > EDA/PCB > 設計應用 > Backdrill相關設置及Backdrill文檔輸出方法

Backdrill相關設置及Backdrill文檔輸出方法

作者: 時間:2010-05-11 來源:網絡 收藏

5.定義層(可選)

User Overrides

In most cases, the backdrill layer ranges defined in the Setup and Analysis user interface satisfy your requirements to manage stubs. The BACKDRILL_OVERRIDE property allows user-specified control of layer ranges for any pin or via and from ether side of the board or both. This is done regardless of violations that may result, such as testpoint conflicts or backdrilling through a connection. The override property was considered for the design of test coupons where the OEM wishes to evaluate the performance of the board fabricator with respect to the adherence of depth ranges. The designer may override the to layer to effectively drill out the layer where the trace connects the pin/via. The expected usage of this property is limited; please exercise caution to prevent accidental over-drilling.

本文引用地址:http://m.ptau.cn/article/191721.htm

Property

BACKDRILL_OVERRIDE

Purpose

User-specified backdrill range

Usage

Optional: special circumstances

Value

TOP:layer_name>:BOTTOM:layer_name>

Objects

Pins, Vias

analysis flag

O or W (warning)


定義:在Manufacture>NC … setup and analysis

6.NC>DRILLLENGEND,輸出鉆孔表,注意要選擇 Include backdrill
>

7.產生鉆孔文件,輸出鉆孔文件,也要s Include backdrill


上一頁 1 2 3 下一頁

關鍵詞: Backdrill 文檔 方法

評論


相關推薦

技術專區

關閉